久久亚洲最大成人网4438,亚洲精品资源,亚洲免费人成在线视频观看,亚洲欧美一区二区三区久本道,国产视频网,日韩在线观看精品,久久精品影院一区二区三区

  • TEL:0574-83067022
  • Service
  • Tel
    0574-83067022
  • Message
  • ZhengLi
  • Solution to Low Rotary Power of Hydraulic Cylinder Pressure
    Date:2019-06-24 13:43:56 Clicks:4191

    During the hydraulic cylinder test and pressure assembly platform, the hydraulic tubing was inserted into the hydraulic cylinder tubing, and the hydraulic oil was inflated three times. It was found that the leakage sound of the hydraulic cylinder proved that there was a problem with the hydraulic sealing gasket of the cylinder seal.


    It is necessary to replace the hydraulic seal gasket in time. If the cylinder leakage still occurs after the replacement of the gasket, the pressure value can not reach a certain rotary cylinder diameter strength, and the screw opening of the hydraulic cylinder is worn out, it should be used after welding, deburring, increasing the hydraulic oil seal, and then pressurizing again to test the pressure rotary strength of the cylinder, so that the normal pressure value of the cylinder rod can be used normally when it rotates.


    Pumps, motors, valves, cylinders and other components are worn, and the resistance of oil is too large. For example, the inner diameter of pipeline and the flow rate of demand are not suitable. Perhaps because the valve standard is too small and the energy loss is too large, there is a heat source nearby. Solutions for large radiation heat are as follows: lowering the pressure to the appropriate level to improve the unloading circuit planning under satisfactory operating conditions; checking the electric control circuit and the corresponding valve movement. To reduce unloading pressure; when high pressure and low pressure and large flow, choose variable pump, change large accumulator, repair accumulator, clean or replace oil filter; refuel to regular oil level, replace oil suitable for viscosity, check cooling water system, replace and repair solenoid water valve; replace and repair electric fan, clean, repair or replace cooler, refit cooling system or increase tank capacity. Replacement of worn components, equipment suitable for scale pipes and valves, selection of heat insulation material reflector or change the place of placement, installation of ventilation, cooling equipment, etc. Choose suitable working oil. The low pressure of hydraulic pipe lock machine may be caused by improper adjustment of relief valve. It can adjust the pressure of relief valve progressive system. The speed of motor has nothing to do with the flow rate of your pump and does not affect the pressure of your system.


    Ningbo Zhengli Hydraulic Technology Co., Ltd.
    ADD:Huang Ai Industrial Zone, Dongqianhu Town
    TEL:0574-83067022
    FAX:0574-83067171
    MOBI:13355907839
    Friendship link